3D Printing Club GTA meetup at Shop3D.ca, Thurs Nov 24

Time for a little intro session.  We are planning to hold a meetup for beginners and those interested in 3D printing with consumer desktop 3D printers. We’ll be using the open source Ultimaker 2+ as the demo but this should be a good intro to most types of FDM printers on the market.

Jacky and Kyle will go through all the steps from downloading a model to slicing and then preparing the 3D printer for printing.  Open Q&A afterwards.  Hope to see you there!

Session Info:  

Thursday, November 24, 2016
to

RSVP your spot via the the meetup group for 3D Printing Club GTA.

Shop3D.ca is your source for all Ultimaker/Zotrax/Formlabs/BCN3D 3D printers and consumables in Canada. Run by expert printsmen who test each and every product they carry in their inventory. Printers, Filaments, Parts, Advice and Support all in one place.

Leave a Reply

Your email address will not be published. Required fields are marked *