The Olsson Ruby is now in stock at Shop3D.ca

The Olsson Ruby’s are here!  In stock and ready to ship out with 2 diameters for a wide variety of printers.

Our partnership with Olsson Ruby means you’ll be able to upgrade to the best 3D Printing Nozzle ever made for your Ultimaker 2+ Family or any E3D hotends.  The Olsson Ruby is far more wear resistant than even the Hardened Steel nozzles yet it has the conductivity of your regular brass nozzle.  All of the upsides and none of the downsides.  Now that is a marvel.

Grab yours today from the Olsson Ruby page.  I might be the last nozzle you’ll ever need…

Compability List:

2.85mm versions
Ultimaker 2+
Ultimaker 2+ Extended
Ultimaker 2 with Olsson block upgrade
Ultimaker 2 Extended with Olsson block upgrade
Ultimaker Original *1 *2
Ultimaker Original+ *1 *2
Lulzbot TAZ 3 with hexagon hotend upgrade *2
Lulzbot TAZ 4 with hexagon hotend upgrade *2
Lulzbot TAZ 5
Lulzbot TAZ 6 *2 *3
Every printer with a E3D V4 3.0mm hotend *2
Every printer with a E3D V5 3.0mm hotend *2
Every printer with a E3D V6 3.0mm hotend *2

1.75mm versions
Every printer with a E3D V4/V5/V6 1.75mm hotend, including:
Prusa Research i3 MK2
E3D BigBox
Makerbot Replicator 2/2X *4

*1 = You will need to adjust the fan shroud since the nozzle is shorter than the original nozzle.
*2 = You will need to mount it with the nozzle not placed against the front face of the heater block but against the heat break/isolator tube to create a seal.
*3 = Will require disabling of the automatic bed leveling since the ruby tip is not conductive.
*4 = Several testers reports success

For more information on the Olsson Ruby, visit www.olssonruby.com

Shop3D.ca is your source for all Ultimaker/Zotrax/Formlabs/BCN3D 3D printers and consumables in Canada. Run by expert printsmen who test each and every product they carry in their inventory. Printers, Filaments, Parts, Advice and Support all in one place.

Leave a Reply

Your email address will not be published. Required fields are marked *