Free Shipping over $200 | Orders ship out at 2pm Monday-Friday

3D PRINTING CLUB GTA MEETUP AT SHOP3D.CA, THURS NOV 24

November 21, 2016

Time for a little intro session.  We are planning to hold a meetup for beginners and those interested in 3D printing with consumer desktop 3D printers. We’ll be using the open source Ultimaker 2+ as the demo but this should be a good intro to most types of FDM printers on the market.

Jacky and Kyle will go through all the steps from downloading a model to slicing and then preparing the 3D printer for printing.  Open Q&A afterwards.  Hope to see you there!

Session Info:  

Thursday, November 24, 2016
 to 

RSVP your spot via the the meetup group for 3D Printing Club GTA.



Also in News

New from Ultimaker: CC Core 0.4/0.6
New from Ultimaker: CC Core 0.4/0.6

July 22, 2021

The new Ultimaker CC cores 0.4mm & 0.6mm enable you to optimize your applications for use in all types of industry. They are primed to seamlessly print on demand with a variety of materials, from PLA to composites.

Continue Reading

Top 5 reasons to use TPM instead of IPA
Top 5 reasons to use TPM instead of IPA

July 19, 2021

Choosing the right wash solvent is an important factor to get the best results from your Formlabs SLA printers. Here are 5 reasons why TPM might be a better alternative for you....

Continue Reading

Fuse 1 Demo
Fuse 1 Demo

June 17, 2021

On Tuesday June 29th 2021 at 11:00AM (ET) Shop3D.ca hosted a live demo, in partnership with Formlabs, taking a look at this new SLS 3D Printing system. In this webinar, we've done a deep dive into the Fuse 1 and Fuse Sift. Teaching users how it stacks up to other 3D printing technologies and how it can be used in a variety of applications.

Continue Reading