March 08, 2017
The Olsson Ruby’s are here! In stock and ready to ship out with 2 diameters for a wide variety of printers.
Our partnership with Olsson Ruby means you’ll be able to upgrade to the best 3D Printing Nozzle ever made for your Ultimaker 2+ Family or any E3D hotends. The Olsson Ruby is far more wear resistant than even the Hardened Steel nozzles yet it has the conductivity of your regular brass nozzle. All of the upsides and none of the downsides. Now that is a marvel.
Grab yours today from the Olsson Ruby page. I might be the last nozzle you’ll ever need…
2.85mm versionsUltimaker 2+Ultimaker 2+ ExtendedUltimaker 2 with Olsson block upgradeUltimaker 2 Extended with Olsson block upgradeUltimaker Original *1 *2Ultimaker Original+ *1 *2Lulzbot TAZ 3 with hexagon hotend upgrade *2Lulzbot TAZ 4 with hexagon hotend upgrade *2Lulzbot TAZ 5Lulzbot TAZ 6 *2 *3Every printer with a E3D V4 3.0mm hotend *2Every printer with a E3D V5 3.0mm hotend *2Every printer with a E3D V6 3.0mm hotend *2
1.75mm versionsEvery printer with a E3D V4/V5/V6 1.75mm hotend, including:Prusa Research i3 MK2E3D BigBoxMakerbot Replicator 2/2X *4
*1 = You will need to adjust the fan shroud since the nozzle is shorter than the original nozzle.*2 = You will need to mount it with the nozzle not placed against the front face of the heater block but against the heat break/isolator tube to create a seal.*3 = Will require disabling of the automatic bed leveling since the ruby tip is not conductive.*4 = Several testers reports success
For more information on the Olsson Ruby, visit www.olssonruby.com
Comments will be approved before showing up.
June 30, 2020
June 22, 2020
June 11, 2020
Subscribe to our newsletter and always be the first to hear about what is happening.