Free Shipping over $200 (Ships same day if order placed before 2pm M-F)
December 02, 2015
Ever felt like you needed a replacement PTFE Coupler but it doesn’t feel worth it to just order that one tiny part? As well, ever wanted to try the CPE filament from Ultimaker but found it just a bit too pricey for a single spool? Well this is a fortunate circumstance.
One of the reasons why the CPE filament is more costly is for each spool, a PTFE Cooupler for the Ultimaker 2 is INCLUDED with it. As CPE melts at a higher temperature, Ultimaker felt that this may wear down the PTFE Coupler faster than with PLA so they have included a spare as a preventative measure. If you factor in a PTFE Coupler with the cost of the CPE filament, it actually turns out to be similarly priced with both Ultimaker PLA and ABS.
* This Promo has now been discontinued *
Comments will be approved before showing up.
October 23, 2017
October 22, 2017
October 18, 2017
Subscribe to our newsletter and always be the first to hear about what is happening.