Advanced 3D Printing Kit for Ultimaker 3 & 3 Extended

• x 1 front enclosure
• x 25 adhesion sheets
• x 1 adhesive applicator
• x 1 glass plate

The Advanced 3D Printing Kit can be used in combination with all Ultimaker filaments, although the benefits are greater for some materials than for others. See the table below for an overview of the compatibility and advice:

Material	Front enclosure	Adhesion sheet
PLA	Optional	Optional
ABS	Highly recommended	Optional
CPE	Optional	Optional
CPE+	Highly recommended	Recommended
Nylon	Optional	Optional
PC	Highly recommended	Highly recommended
TPU 95A	Optional	Not advised
PP	Highly recommended	Required
PVA	Optional	Optional

FRONT ENCLOSURE ADD-ON
The front enclosure is very effective when using materials that are prone to warping or delaminating. It stops heat from escaping, creating a constant temperature of 45 ºC, while also protecting the print from external influences. The stable environment ensures that the printed material cools down more slowly and that the temperature is more evenly distributed throughout the print. This helps lower shrinkage and decreases the risk of warping and delamination. You can find detailed instructions on how to install the front enclosure here.

ADHESION SHEETS
The adhesion sheets improve build plate adhesion and can be used with most materials. They make a great alternative to a glue stick and are designed for multiple use. To create a flat printing surface, it’s important to ensure the sheet is applied correctly to prevent air bubbles. You can find instructions on how to apply the sheet here.

GLASS PLATE
In addition to the above add-ons that increase reliability while printing, the Advanced 3D Printing Kit also features a glass plate. This extra glass plate means you no longer have to wait to remove the finished print from the Ultimaker 3 printer. Instead, you can quickly swap the glass plate for a new one, allowing you to directly start a new print, which minimizes downtime. Take a look at the Ultimaker 3 manual for instructions on how to install the glass plate.

The use of the front enclosure is strongly advised for most filaments that print at higher temperatures and that may have problems with layer bonding.

The front enclosure controls the temperature inside the printer, which prevents delamination and improves the print surface quality. For the other materials (PLA, CPE, Nylon, and TPU 95A) the front enclosure is not necessary. However, the use of this add-on will not negatively impact print quality and may even lead to more reliable print results.

The adhesion sheets are required for PP and (highly) recommended for CPE+ and PC. These materials require a high build plate temperature, but despite this high temperature, they may still have problems with build plate adhesion.

Adhesion sheets are optional for most of the other materials, as they replace the use of the glue stick.