Elma P300H / P180H Ultrasonic Cleaning Unit (Form 3L) (Pre-order)

1. Fill the main Ultrasonic chamber with 3-4L of water with a little bit of soap
2. Fill the Plastic Bin with TPM
3. Place the bin in the main chamber
Place the part in the bin
4. Run for 15 minutes (may vary depending on geometry)
5. Heat off
6. Mode Sweep
7. 80 kHz
8. Power 100%
9. Let Part drip dry
10. Rinse your part in soapy water (leave for 30 mins)
11. Let your part dry (until water is evaporated)
12. Post Cure if required.

*TPM and water can be left in the machine (do not need to clean out each time on use)

 *Tub may not fit a full build volume 3L print. In such cases, you can rinse half, flip around and rinse the other half.

• MULTI-FREQUENCY
  Wash at 37 kHz (standard applications) to 80kHz (ideal for small and sensitive items)
  
• PULSE-FUNCTION
  Additional power through increased peak performance
  
• DEGAS
  For the quick degassing of samples and HPLC solvents.
  
• POWER CONTROL
  Optimized power regulation for special cleaning and laboratory applications

• WHY TPM?
  Because of the larger build volume of the 3L, a larger tank is required to clean the parts. A large amount of IPA can evaporate quickly and become a fire hazard. TPM is non flammable, has low evaporation and high absorption rate for resins making it a more ideal choice for the 3L post processing.
  
• P100H or P300H?
  This depends on the size of prints you commonly make, we recommend making the distinction based on the maximum size of parts you intend to make. Compare the internal tub sizes to see if it fits. Both units functional the same besides the size.
  
• What is the warranty like?
  2 year warranty is provided by the manufacturer (Elma)