Easy Support Removal

Specially formulated for ABS, our support material adheres precisely to the ABS surface, allowing for easy support removal. This streamlines your post-processing work, ensuring a more efficient workflow.

Superior Support Interface Quality

Support for ABS enables a 0 Top Z distance and 0 Top interface spacing when printing, ensuring a scar free support surface. This enhances the sharpness of details, improving the overall appearance and integrity of your final prints.

RFID for Intelligent Printing

All printing parameters are embedded in RFID, which can be read through the Bambu Lab AMS (Automatic Material System). Load and print! No more tedious setting steps.

Printing Tips

• Support for ABS is soluble in limonene. Please pay attention to the usage norms and safety.
• Pungent and unpleasant odors may be released during printing. Make sure your printer is enclosed and placed in a well-ventilated area.
• When layer strength is required, it is recommended to increase the flushing volume to above 800 mm³. If the flushing is not thorough, it may reduce the layer adhesion of the model at surfaces that are on the same horizontal plane as the support surface.
• By increasing the "initial layer speed", a more peelable support can be obtained. However, this will increase the risk of warping.
• Dry out before use for higher print quality. Drying conditions: 80℃ for 4 hrs in the blast drying oven; 85 - 95 ℃ for 6 hrs in the X1 Series Heatbed. Please refer to Filament drying instructions on WIKI

Recommended Printing Settings

• Drying Settings (Blast Drying Oven): 80 °C, 4 h
• Printing and Keeping Container's Humidity: < 20% RH (Sealed, with Desiccant)
• Nozzle Temperature: 240 - 270 °C
• Bed Temperature (with Glue): 80 - 100 °C
• Printing Speed: < 100 mm/s

Physical Properties

• Density: 1.16 g/cm³
• Vicat Softening Temperature: N / A
• Heat Deflection Temperature: N / A
• Melting Temperature: 195 °C
• Melt Index: 11.6 ± 0.7 g/10 min

Attribute Comparison

• Colour: White
• Nozzle Type: 0.4 / 0.6 / 0.8 mm
• Nozzle Temperature: 240 - 270 °C
• Bed Temperature: 80 - 100 °C
• Print Speed: < 100 mm/s
• Water Soluble: Water-insoluble, limonene-dissolvable
• Dry before Use: PLA, PETG
• Dry Protection during Use: Optional
• Filament Compatibility: ABS

Accessory Compatibility

• Build Plate: Smooth PEI Plate, Textured PEI Plate
• Hotend: Hotend with Hardened Steel Nozzle 0.4 mm / 0.6 mm / 0.8 mm
• Bambu Liquid / Glue Stick: Bambu Liquid Glue / Glue Stick