Calling All Library Staff & Educators!

March 28, 2018

Calling All Library Staff & Educators!

**Please note that the date for the event has been changed.**

This past February, Shop3D.ca took part in the OLA Super Conference Expo.

We met hundreds of educators and members of libraries across Canada and had the opportunity to chat about 3D printing.

Knowing that there were going to be some myths revolving around 3D printing that needed to be debunked and questions, we set out to gauge interest in a meet up. We were overwhelmed by the amount of interest that was given on learning how 3D printing could be used in a library/makerspace, and whats more, we were surprised by the range of questions we had received.

Not one to back down from a challenge, on **Monday, June 4, 2018** from 10am to 4pm, Shop3D.ca will be holding an intensive workshop at the Meadowvale Public Library specially catered to Libraries and Educators.

Lunch will be provided for one attendee per ticket. Tickets will not be available at the door. Space is limited, please register while quantities last.

If you are buying a ticket for someone other than yourself or a group, please be sure to include their names in the notes upon check out.

For more details on the topics that will be covered and or reserve your seat at the event, click here to for more information or to book tickets.

 




Leave a comment

Comments will be approved before showing up.


Also in News

Introducing  BCN3D's Sigma R19 3D Printer
Introducing BCN3D's Sigma R19 3D Printer

October 11, 2018

Perfect for makers, prototypers and engineers looking to reduce print times while printing multiples of the same part.

Continue Reading

New Lab innovators print their way to faster iterations and design freedom
New Lab innovators print their way to faster iterations and design freedom

October 10, 2018

“For the members who might be interested in 3D printing, and in integrating 3D printing into their workflow, the largest barrier was that they either assumed that 3D printing could do anything, or that it couldn’t do the thing they needed it to,”

Continue Reading

The New Ultimaker Print Core - CC RED 0.6 mm
The New Ultimaker Print Core - CC RED 0.6 mm

September 25, 2018

To enable simple printing of composite materials, Ultimaker is launching a new print core CC Red 0.6 mm. 

Continue Reading