MakerBot announces the release of their Experimental Extruder

October 18, 2017

MakerBot announces the release of their Experimental Extruder

Customize Your 3D Printing Experience

If you have been looking for a way to change nozzle sizes or to a hard nozzle on your MakerBot printer, then you are in luck!  Designed for the Advanced User who wants to push the limits of what’s possible on MakerBot 3D Printers to allow you to use a flexible range of materials and fits all current generation MakerBot models.

Along with the extruder hotend, you will receive:

  • 2 x Wrenches
  • 4 x interchangeable nozzles (0.4mm, 0.6mm, 0.8mm, Steel 0.6mm)
  • Access to new print modes

Visit MakerBot Labs For more information!

Pre-order yours today!  We expect to stock them in store within 4 weeks.

Note:  The Experimental Extruder is an experimental product and is not covered under warranty or Makercare.  

 



Leave a comment

Comments will be approved before showing up.


Also in News

Introducing  BCN3D's Sigma R19 3D Printer
Introducing BCN3D's Sigma R19 3D Printer

October 11, 2018

Perfect for makers, prototypers and engineers looking to reduce print times while printing multiples of the same part.

Continue Reading

New Lab innovators print their way to faster iterations and design freedom
New Lab innovators print their way to faster iterations and design freedom

October 10, 2018

“For the members who might be interested in 3D printing, and in integrating 3D printing into their workflow, the largest barrier was that they either assumed that 3D printing could do anything, or that it couldn’t do the thing they needed it to,”

Continue Reading

The New Ultimaker Print Core - CC RED 0.6 mm
The New Ultimaker Print Core - CC RED 0.6 mm

September 25, 2018

To enable simple printing of composite materials, Ultimaker is launching a new print core CC Red 0.6 mm. 

Continue Reading