October 17, 2017
Ultimaker has just announced the release of Ultimaker 3.0.
While this might seem very soon considering the release of 2.7 there are several changes that will make all of our 3D slicing lives easier.
For starters the User Interface (UI) has been streamlined. They have implemented sliders for recommending parameters for layer height, print speed and infill. The build plate now shows high graduations to allow for a more precise positioning of your prints and to top it off, Cura will have a faster start up time!
For a full break down of what you can look forward to with Cura 3.0, click here.
October 15, 2020
September 17, 2020
Take a closer look at the new line-up of printers at BCN3D and each of their comparisons. Introducing the all new W50, W27, and D25 3D Printers. Now including the BCN3D Smart Cabinet, the environment-controlled filament storage unit.
Click here to see what these printers can do for your next print project.
August 25, 2020
Subscribe to our newsletter and always be the first to hear about what is happening.